Weather station with ultrasonic sensors, active output (0-10 V), digital output (Modbus RTU)

SKU: FS6002

Category: Sensors

Manufacturer: FuehlerSysteme

wind speed
precipitation yes/no
brightness (east/south/west)
temperature
humidity
twilight

humidity

Output: 0-10 V, Modbus RTU
Equipment: without

GPS
Description: Wind: 0-60 m/s, 0-360°

Wind: 0-60 m/s, 0-360°, Brightness: 0-150 kLux, Precipitation: 0-999 mm/h

Wind: 0-60 m/s, 0-360°, Temperature: -50...+80°C, Humidity: 0-100% r.h., Air pressure: 500-1200 hPa

Wind: 0-60 m/s, 0-360°, Temperature: -50...+80°C, Humidity: 0-100% r.h., Air pressure: 500-1200 hPa, Brightness: 0-150 kLux, Precipitation: 0-999 mm/h

Low stock level

from 1.737,98 €

incl. 19% VAT , plus

This item has variations. Please select the requested variation.

The weather station FS6002 is used to detect the most important meteorological parameters. Depending on the configuration, the device provides the measurement data of wind speed / direction, air temperature, relative humidity, barometric air pressure, precipitation and brightness. For a correct determination of the wind direction in mobile use of the weather station, a magnetic compass is integrated in all device variants. Furthermore, a built-in GPS receiver is used to determine the exact world time and geographical position. The wind speed and wind direction is determined by the detection of the 2-dimensional horizontal components of mutually perpendicular ultrasonic measuring sections. In addition, the sound velocity can be used to calculate and output the acoustic virtual temperature. Due to the measuring principle of the ultrasonic transit time measurement, the device is ideally suited to the inertia-free wind gust and peak value measurement. The air temperature and relative humidity are measured by an integrated and accurate combination sensor, which is protected against harmful environmental influences by a water-impermeable but water vapor-open microporous filter. The integrated pressure sensor based on MEMs (micro-electro-mechanical-system) technology is also protected with such a filter. In the measurement of precipitation intensity, the precipitate is measured and calculated contactlessly via the back-reflected signal of a Doppler radar. The intensity of the last minute is extrapolated for the output to one hour. The brightness is recorded by 4 photosensors with a spectral sensitivity curve adapted to the sensitivity of the eyes and the intensity ratio is used to calculate the direction of the light source. The weather station has a built-in heater. This largely prevents an ice and snow on the device. The data output can be analog, as standard signal and / or as digital (MODBUS RTU). 8 analog output channels (0-10 V) are available, 5 channels of which can optionally be configured universally.

Manufacturer information:

FuehlerSysteme eNET International GmbH
Röthensteig 11
90408 Nürnberg

+49 911 37322-0
info@fuehlersysteme.de

Measurement range temp.:	-40...+80°C, resolution 0,1 K
Measurement range brightness:	0-150 kLux, resolution ca. 0,3% f. mv.
Measurement range air pressure:	500-1200 hPa, resolution 0,1 hPa
Measurement range precipitation:	0-999 mm/h, resolution 0,001 mm/h
Measurement range r.H.:	0-100% r.h., resolution 0,1% r.h.
Measurement range wind speed:	0-60 m/s, resolution 0,1 m/s
Measuring range wind direction:	0-360°, resolution 1°
Accuracy humidity:	±1,8% (10-90% r.H.), ±3% (0-100% r.H.)
Accuracy brightness:	±3% from relative measured value, ±2° in direct sunlight without cloud cover
Accuracy air pressure:	±0,1 hPa (0...+65°C, 800-1100 hPa), ±1 hPa (-40...+65°C, 500-1200 hPa)
Accuracy precipitation:	At 95% of precipitation deviations smaller than 10% compared to laser precipitation monitor (reference)
Accuracy temperature:	±0,3 K (25°C), ±1,0 K (-40...+80°C)
Accuracy wind speed:	±0,3 m/s (< 5 m/s, rms - average over 360°), else ±3% f. measured value (rms - average over 360°)
Accuracy wind direction:	±2,0° at ws > 2 m/s
Supply voltage:	6...40 V DC or 10...28 V AC 50 Hz / 60 Hz (without heating), 24 V AC/DC ±15% (with heating)
Analogue output:	0-10 V, resolution 16 bit
Digital output:	Modbus RTU
Electrical connection:	19-pole connector, cable 16 x 0,25 alternative 8 x 0,25 (cable not included)
Housing:	polycarbonate PC, UV-stabilised, white RAL 9003
Dimensions:	Ø 150 x 220 / 175 mm
Weight:	ca. 900 g
Protection type:	IP67
Working temperature:	-40...+70°C
Storage temperature:	-20...+70°C
Installation:	Mast tube R 1½ inch (Ø 48.3 mm)
Approvals:	CE, EAC, RoHS