Oxygen Transducer for surface mounting, with display, with changeover contact, Modbus RTU

SKU: FS1309

Category: Air Quality

0...25% vol. optional 0...100% vol.
Modbus RTU, relay
LCD-Display
hinge lock technology

Output: Modbus RTU
Equipment: without

Display

Display, Relay

Relay
Measurement range O2: 0...25%

from 692,84 €

incl. 19% VAT , plus

This item has variations. Please select the requested variation.

The measuring device detects the oxygen level O2 (0...25/100% vol.) in the ambient air. The transmitter converts the measured value into a standardized, digital output signal Modbus RTU. As an option, the measuring device has a backlit, rotatable display and potential-free changeover contact. In the version with a backlit LCD display, the measured values and min/max values are displayed. The switching threshold and hysteresis can be set as required using a bus command. Measured values from other bus users can be shown in the display as special functions. To display measured values from other bus users, these are entered by the bus master in the appropriate registers. The optional changeover contact can also be used for measured values from other bus users. The address, transmission mode/speed, terminating resistor and master/slave function of the bus devices are conveniently configured using innovative DIP switch technology. This means that the devices can be integrated quickly and easily into the system and later parameterized via the master. The bus devices can even be reset to factory settings by the master during operation. The basic functionality of the device is restored in a matter of seconds. This can happen with incorrect parameterizations of e.g. Offset, switching threshold, display modes etc. may be necessary. The housing with innovative hinge locking technology, double PG screw connection, sufficient terminal space and easy-to-connect push-in connection terminals offers maximum installation freedom and speed. The oxygen measuring device is ideal for use in workplaces and medical facilities.

Manufacturer information:

FuehlerSysteme eNET International GmbH
Röthensteig 11
90408 Nürnberg

+49 911 37322-0
info@fuehlersysteme.de

Measurement range O2:	0...25% vol. optional 0...100% vol
Accuracy O2:	± 0,2% vol. + max. ±0,5% FS (@ 20°C, 45% r.H., 1013 mbar)
Temperature dependency:	±1% FS / 10 K
Long term stability:	±0,2% FS/year by auto-calibration ON
Sensor:	Electrochemical sensor
Response time (t90):	< 1 s
Supply voltage:	24 V DC (±5%)
Current consumption:	15mA; R: 15mA (Peak 35mA at the moment the relay is switched); D (DBL on): 40mA; RD: 40mA (DBL on, Peak 60mA at the moment the relay is switched)
Alarm output:	1 x potential-free change-over contact, 48 V, 1 A
Digital output:	Modbus RTU
Switching Hysteresis Relay:	can be entered in the register
Electrical connection:	push-in terminal, no tools required, time-saving
Display:	optional LCD display with backlight on/off/auto
Cable gland:	PG11 high-strength cable gland with strain relief
Housing:	Polycarbonate PC UL 94 V0 with hinge locks, color signal white similar to RAL 9003
Dimensions:	Housing: L 89 x W 80 x H 47 mm
Protection type:	IP65 (housing/electronic), IP20 (sensor)
Protection class:	III
Working range r.H.:	0...98% r.H. in contaminant-free, non-condensing air
Working temperature:	0...+50°C
Storage temperature:	-20...+50°C
Installation:	screw fastening
Approvals:	CE, RoHS